PSK31 is a very popular mode so no RSIDs are used. The RSID can take up more bandwidth than the digital mode and is not used on many common modes. It is possible to decode the RSID and not decode data due to a weak signal. On reception of an RSID, the mode is changed. RxID and TxID encode and decode the Reed-Solomon Identification (RSID) for identifying digital modes.The frequency can be fine-tuned with the “adjust cursor frequency” adjustment. MT63-2000L (or MT63-2KL) is most often used by the net and NBEMS.įldigi will now show “MT63-2KL” in the lower left status line.Blocking this firewall exception will not allow programs in the suite to communicate and result in undesired operation. Fldigi sets up a local server to communicate with other programs.If you are a standard user, you will need the administrator password. SignaLink USB users do not need to set these options. If the transceiver requires keying control, select it using one of the control methods and configure those options. See the “Calibration” section at the beginning of this document for methods to calibrate Fldigi. Sound card calibration is recommended regardless of mode. Corrections are not as important for MT63-2KL on FM.The remaining settings are the default settings. Under Correction, enter the RX ppm and TX ppm for your interface device. WDM-KS is the lowest latency, followed by DirectSound, and MME most compatible. Additional audio architecture options maybe presented.SignaLink USB is labeled USB Audio CODEC in PortAudio.At a multi-operator setting (Field Day), the Station Callsign would be the club call and Operator Callsign would be the individual operating.Ĭlick the receive audio interface device.Ĭlick the transmit audio interface device. In a single operator setting, Station Callsign and Operator Callsign are the same.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |